Getting Started
Your package should contain:
1 x Vattendance PBX
1 x Vattendance Smart Button
1 x Power adapter
1 x RJ45 Ethernet Cable

Back of PBX

Plug the power adapter into power port on the Vattendance Appliance.
Plug the Ethernet cable into the Ethernet port on the Vattendance Appliance. Plug the
other end into any switch port of your router.
Find the appropriate 3.5mm audio cables to suit your Kingdom Hall’s Sound System.
Locate the four 3.5mm audio ports on the back of the PBX (see above). They are in a
square formation on the right hand side of the above picture
Plug the 3.5mm end into the bottom left audio port on the Vattendance Appliance (see
picture above). Plug the other end into an output on your sound system. This is feeding
audio into your Vattendance Appliance so that it can be transmitted to the conference.
Take a second audio cable and plug the 3.5mm end into the bottom right audio port on
the Vattendance appliance (See above). Then plug the other end of the cable into an
input of your sound system. This is feeding audio from your Vattendance Appliance into
the sound system whenever a caller is answering.
Plug the Vattendance smart button into a USB port on the PBX. This will be used to
accept an answer from callers.
Plug the power adapter into a power point and turn it on.

Suggestions
Place the Appliance in an area that is well ventilated
Use a power surge protector
Wire the sound desk with an “always connected” power point. The PBX needs to run at
all times to allow access to recorded meetings.